Bradzuzu
Senior Member

ya i gt the exhaust dne but havent gt the motivation for the tcase yet

guess it will be longer than i thought to get to go out now i need to weld my exhaust up again and change out a seal and bearing in my tcase

well i used to get good mileage then i built the motor lol i did a torquer cam, weber, bored 40 over port polished head bigger valves ect, header to 2.5 inch pipe to a knock off flowmaster, the motors balanced and its got 529s also lots more dne gas stealing wise and i have a led ft from hell but wat 20 yr old dnt right 6600 miles so faR. i honestly dnt know wat i get but i burn half to over half a tank going 120 miles to eugene going 70 so ya

body damage i dont care about lol ill slam into stuff if i have to just cosmetical itll buff out , but my whole trucks been gone through pretty much all new so im ready for something you guys go and do just need to save some gas funds shes a hog when it comes to that

ya hopefully except this is my dd so i cant afford to break it right now

i guess if u live in vancouver lol ya i live right next to the mall

hey noticed your in van new here figured id say wats up

hey brad,
i was looking to get a skid plate built for my tacoma. and was woundering if you would be be able to help me out with that.

is that t case what you need? if not ill keep looking.

I need to change the U joints on the front axles in my F350, I don't use 4wd much .. Usually down in the sand to get out to camp ... I've horked on it prity hard before with the camper and trailer on back loaded with my sister in laws car ... I've yet to drag the toy hauler out into the sand with my truck... My buddy use to...